Forum: Evaluation Kits
Login to subscribe to this thread via email
Topic: binaries for jennic 5148 ek010 demonstration kit required|
how to read stored program in JN5148-EK010 controller node Hi, I want to read the pre-installed program in JN-5148 EK010 controller sensor node. The problem is I am unable to read the config - register ID , through the flash programmer software that I have. Can somebody assist, if I need a separate programming device or I only need to add relevant drivers to my PC. Please note that I cannot read the config-register ID of any of the nodes, I suspect because of some missing driver.
Regards Saneeha Posted by: saneeha Monday 9th April, 2012 at 10:56am |
| Reply To this Message Quote this Message |
Post
Add a Post
Quote post as a basis for post
New post
There are currently 381 people using the Forum out of a total of 5409 registered users